Activate second Ethernet port

The activation of the second Ethernet port must be done from a SSH terminal. We recommend using Putty (https://www.putty.org/).

Connect to the DINGO device via SSH terminal and follow these instructions:

  1. sudo dingo-config

  2. Go to "3 Network setup"

  3. Then go to "10 Activate Ethernet 2 port"

  4. Then reboot to take effect: sudo reboot

When the DINGO device has been rebooted, run this command: ifconfig , to ensure that the second Ethernet port has been activated. The second Ethernet port is labled eth1.

eth1 is by default on DHCP. If eth1 should be configured to a static IP address, then connect to the DINGO device via DINGO-Manager and do the necessary configurations here.

If it is desired to deactivate the second Ethernet port, then follow the dingo-config instructions above and choose "11 Deactivate Ethernet 2 port" from the network setup menu.